GEEKVAPE G Series Coil 0.6ohm, 0.8ohm, 1.0ohm, 1.2ohm, 1.2M ohm, 1.2S ohm, 1.8ohm Replacement Coils in Dubai, UAE – 5 Pieces Per Pack

The Geekvape G Series coils are low-power replacement coils for Geekvape’s Aegis Pod, AP2, Wenax Stylus, Wenax S-C and Wenax C1 pod kits and related devices, sold in a pack of 5. At Vapor AE you can choose G 0.6Ω, G 0.8Ω, G 1.0Ω, G 1.8Ω or G ST 1.2Ω. They cost AED 49 per pack, with 24-hour delivery to all seven emirates.

Jump to: Specifications · Which G Coil to Choose · Compatibility · How Long a Coil Lasts · How to Fit and Prime · Best E-Liquid · UAE Rules · How to Buy · Pros & Cons · FAQ

Geekvape G Series Coils — Specifications

Wattages and compatibility are from Geekvape’s official G Series coil page; the mesh construction is from retailer listings. Geekvape makes three different 1.2Ω G coils (G1.2, G1.2 M and G1.2 S), each for different devices. Our “G ST 1.2” option does not say which one it is, so check the coil code on the pack against your device before use.

Which G Series Coil Should You Choose?

All G coils are low-power coils for mouth-to-lung (MTL) and restricted direct-lung (RDL) vaping. The lower the resistance, the more power it takes and the looser and warmer the draw.

G 0.6Ω (13–18W)

The warmest option, with the most vapour. It suits an RDL draw and fits the widest range of devices: Geekvape lists the Aegis Pod, AP2, Wenax Stylus, Wenax S-C, Wenax C1, and the Digiflavor DU and DIGI-UNO pod kits.

G 0.8Ω (12–15W) and G 1.0Ω (10–12W)

The middle options. They give a tighter draw than the 0.6Ω and suit MTL vaping with nicotine salts. Geekvape lists the G0.8 for the AP2 and Wenax C1.

G 1.2Ω (our G ST 1.2)

A tight MTL coil. The standard G1.2 (9.5–11.5W) is listed for the Wenax Stylus. The G1.2 M is for the Wenax S-C and DU pod kits, and the G1.2 S is for the G18 kit and Siren G MTL tank. Match the code on the pack to your device.

G 1.8Ω (7–9W)

The tightest and coolest option, listed by Geekvape for the G18 kit. It gives a classic cigarette-style draw at very low power.

Which Devices Do G Series Coils Fit?

G coils fit Geekvape and Digiflavor devices built around the G coil. At Vapor AE, the Geekvape Wenax SC uses them (Geekvape lists the G 0.6Ω and G 1.2Ω M for the Wenax S-C). If your Geekvape device uses a different coil family, these packs may be what you need instead:

Browse the full Geekvape range for other coils and pods.

How Long Does a G Coil Last?

Coil life depends on how much you vape, the power you use and the e-liquid. Sweet e-liquids caramelise on the coil faster; tobacco and menthol flavours are usually gentler. Low-power MTL coils like these generally last longer than high-power coils.

Replace the coil when you notice any of these signs:

• The flavour turns muted or burnt even after a refill.
• The vapour becomes thinner at the same setting.
• The pod starts to gurgle or leak.

How to Fit and Prime a G Coil

1. Remove the pod from the device and empty any old e-liquid.
2. Pull the old coil out of the pod.
3. Drip a few drops of e-liquid onto the cotton through the coil’s side holes.
4. Press the new coil firmly into the pod.
5. Fill the pod and wait about five minutes so the cotton soaks fully.
6. Start at the low end of the coil’s range and raise the power slowly.

Never fire a dry coil. A dry coil burns almost instantly and cannot be recovered.

Best E-Liquid for G Series Coils

G coils run at 7–18W, which suits nicotine salt e-liquid or a thin 50/50 freebase. The 1.0–1.8Ω coils are the best match for salts. With the 0.6Ω coil, a slightly lower strength is more comfortable. Very thick, high-VG e-liquid can struggle to soak small MTL coils. Browse our UAE e-liquids.

UAE Rules for E-Liquid and Coils

Replacement coils contain no nicotine themselves. The rules apply to the e-liquid you use with them. Electronic nicotine products in the UAE must meet UAE.S 5030:2018, which caps e-liquid nicotine at 20mg/mL (2%). From 1 September 2026, a minimum excise price of AED 1 per mL also applies to e-liquid. Sale is restricted to adults 21 and over. See our guide to vaping laws in Dubai and the UAE.

How to Buy Geekvape G Series Coils in the UAE

Geekvape G Series coils cost AED 49 for a pack of 5 at Vapor AE. Choose G 0.6, G 0.8, G 1.0, G 1.8 or G ST 1.2 on this page. Standard delivery takes up to 24 hours to all seven emirates and is free on orders over AED 350, with Express delivery in about 2 hours in Dubai (AED 10 extra). Cash on delivery works across the UAE, or you can pay by bank transfer through a payment link sent when the delivery person arrives. The minimum order is AED 100 on all payment methods. Buyers must be 21+; age is confirmed at the website age gate. See our Shipping & Delivery page.

Pros & Cons

FAQ

Which devices do G coils fit?
Geekvape lists the Aegis Pod, AP2, Wenax Stylus, Wenax S-C, Wenax C1, G18 and the Digiflavor DU and DIGI-UNO kits, with each resistance matched to specific devices.

What is the “G ST 1.2” option?
A 1.2Ω G coil. Geekvape makes three 1.2Ω versions (G1.2, G1.2 M and G1.2 S); check the code on the pack against your device.

Which G coil fits the Wenax SC?
Geekvape lists the G 0.6Ω and the G 1.2Ω M for the Wenax S-C.

Are G coils mesh?
Retailer listings describe the 0.6, 0.8, 1.0 and 1.2Ω G coils as mesh.

How many coils are in a pack?
Five.

Which G coil is best for nicotine salts?
The 1.0Ω or 1.2Ω coils at low power. Keep the strength at or below the UAE’s 20mg/mL cap.

Are these coils genuine Geekvape?
Yes. Every product we sell is genuine stock, covered by our Authenticity Guarantee.

How fast is delivery in Abu Dhabi and Dubai?
Standard delivery takes up to 24 hours to all seven emirates, including Abu Dhabi. Express delivery arrives in about 2 hours in Dubai (AED 10 extra).

Reviewed by Ismail Hossain, Product Specialist — Last reviewed: 28 September 2026. Products on this site contain nicotine, an addictive substance. Sale restricted to adults 21+. Authenticity Guarantee · Responsible Vaping Health Disclaimer.