Aspire AF Replacement Coils Review: Riil X Fit, 0.6 and 1.0 Ohm

Overview

This Aspire AF Replacement Coils review covers the 5-pack of Aspire AF mesh coils sold at Vapor AE for AED 49, in two resistances: 0.6Ω (15-18W) and 1.0Ω (12-15W). Aspire lists both on its official Riil X page, where they are the coils for the Riil X, a 700mAh pod kit with a 2ml side-fill pod.

The short verdict: these are the right coils if you own a Riil X and prefer replacing a small coil to throwing away a whole pod. They are not a universal coil and they are not built for high-wattage devices. This assessment is based on the store listing and Aspire’s published specs, not on hands-on testing, and Vapor AE sells the product. Buyers must be 21+.

Jump to: What Are Aspire AF Replacement Coils and What Is in the Pack? · Aspire AF Replacement Coils Review: 0.6Ω vs 1.0Ω · Which Devices Do Aspire AF Coils Fit? · How to Fit, Prime and Get the Most From an AF Coil · AF Coils vs Pods With Built-In Coils: Comparison Table · Pros and Cons of Aspire AF Replacement Coils · UAE Rules, Storage in Heat and Where to Buy · Frequently Asked Questions

What Are Aspire AF Replacement Coils and What Is in the Pack?

Aspire AF coils are replaceable mesh heating elements. Each pack holds five coils, and you pick 0.6Ω or 1.0Ω on the product page. A coil is the part that heats e-liquid into vapour, so its resistance and wattage rating decide how warm the vapour feels and how quickly e-liquid and battery are used. Aspire’s official Riil X page lists two AF options: AF mesh 0.6Ω rated 15-18W and AF mesh 1.0Ω rated 12-15W.

Mesh is a flat woven metal sheet instead of a round wire. It spreads heat across a larger surface, which is the general reason mesh coils are chosen for even flavour. Our listing describes these as Kanthal AF mesh coils; that wording comes from the store listing rather than Aspire’s page, so treat it as the store’s description.

At AED 49 per pack, the price works out at AED 9.80 per coil (49 divided by 5). The coils contain no e-liquid and no nicotine. They are an accessory that seats inside a pod you fill yourself, and the Riil X kit ships with both resistances according to Aspire, so a spare pack is what you buy once those are used.

Aspire AF Replacement Coils Review: 0.6Ω vs 1.0Ω

The 1.0Ω coil (12-15W) gives a tighter mouth-to-lung draw and uses less e-liquid and battery. The 0.6Ω coil (15-18W) runs a little warmer with a looser draw. Both are low-wattage mesh coils, so neither behaves like a sub-ohm coil.

Resistance and wattage are linked. A lower-resistance coil lets more current through at the same voltage, which produces more heat and vapour. That is why the 0.6Ω coil has a higher wattage range than the 1.0Ω coil, and why running either coil outside its listed range risks a burnt taste or a weak, cool hit.

A retailer listing for the same coil suggests the 1.0Ω option suits 50/50 e-liquids and the 0.6Ω can handle higher-VG liquids. Aspire’s own page does not say this, so consider it general guidance and not a specification. Very thick e-liquid can struggle to soak a small coil, which is a common cause of dry hits.

Which resistance suits nicotine salts?

In our view, the 1.0Ω coil is the natural match for nicotine salt e-liquid, because the tighter draw and lower power suit higher-strength liquids. That is an opinion, not an Aspire claim. Remember the UAE cap of 20mg/mL on e-liquid nicotine: it applies to what you put in the pod, not to the coil.

Which Devices Do Aspire AF Coils Fit?

Aspire lists AF mesh coils for the Riil X, so that is the device we sell them for. The Riil X pod is a separate part with no built-in coil, and the AF coil presses into the base of that pod. Without the matching pod, the coil has nothing to sit in.

One US retailer’s listing says AF coils also work across Aspire’s Flexus range. We could not confirm that on Aspire’s official pages and Vapor AE does not sell Flexus devices, so we only claim the Riil X. If you own another Aspire device, check its own manual before buying.

The Pixo, Pixo Aura and Nexi Pro use pods with the coil built in, so AF coils do not fit them. Those pods are replaced as a whole, which is why the Riil X approach differs: you change the coil and keep the pod until it cracks or leaks.

Why the Pixo and Nexi Pro cannot use AF coils

Built-in-coil pods have their own heating element sealed into the pod. There is no socket for a loose coil. If you own a Pixo, buy the matching Aspire Pixo replacement pods and read our Aspire Pixo Replacement Pod review for how the resistances differ.

How to Fit, Prime and Get the Most From an AF Coil

Priming means soaking the cotton with e-liquid before the first puff. A dry coil burns instantly, and a burnt coil cannot be recovered, so priming is the single most important step. Skipping it is the usual reason a new coil tastes bad on the first draw.

Coil life depends on how much you vape, the wattage and the e-liquid. Sweet, sugary flavours tend to leave residue on the mesh sooner. Aspire does not publish a puff count for these coils, and we have not measured one, so we do not give a lifespan figure. A practical rule is to replace the coil when flavour turns muted or burnt, even after a fresh fill.

Keep the pod clean too. Rinsing it with warm water when you change coils and letting it dry fully before refilling helps prevent leaks. The pod is only replaced when it cracks or leaks at the seams.

Step-by-step priming

Remove the pod and pull out the old coil. Put a few drops of e-liquid on the exposed cotton of the new coil. Push the coil firmly into the pod base, fill from the side leaving a little air space, and wait about five minutes. Refit the pod and take a few gentle puffs first.

AF Coils vs Pods With Built-In Coils: Comparison Table

The table in this Aspire AF Replacement Coils review compares the coil pack with the two related Aspire pod formats sold at Vapor AE. Prices are the listed starting prices, and per-unit cost is derived by dividing the price by the pack size. Rows show the format, the wattage Aspire or our listing gives, and what you would pay for each unit.

On price per unit, the AF coil is cheaper than a Pixo pod, but the two are different formats: the coil needs a pod already, and a Pixo pod works only in Pixo devices. The per-unit figures are arithmetic from listed prices, not a measure of how long each lasts. See the full Aspire range at Vapor AE and our pods and coils category.

Pros and Cons of Aspire AF Replacement Coils

The main advantage is running cost: you replace only the coil. The main drawback is narrow compatibility, because only two resistances are listed for the Riil X and neither suits high-wattage vaping. This section states positives and negatives as separate facts, one pair per row, so you can weigh them against the way you vape and the device you own.

A fair reading of this Aspire AF Replacement Coils review: the coils suit a specific device and a specific style. If you already own the Aspire Riil X Pod Kit, they are the sensible spare. If you do not own a Riil X, they are of no use to you.

UAE Rules, Storage in Heat and Where to Buy

Coils contain no nicotine, but the e-liquid you use with them is regulated. UAE.S 5030:2018 caps e-liquid nicotine at 20mg/mL (2%). From 1 September 2026 a minimum excise price of AED 1 per mL of e-liquid applies. Sale is restricted to adults 21 and over. Our guide to vaping laws in Dubai and the UAE explains the rules, and how long vape puffs last covers usage habits.

For buying, the Aspire AF Replacement Coils 5pcs page lets you choose 0.6Ω or 1.0Ω. Standard delivery takes up to 24 hours to all seven emirates and is free over AED 350. Express delivery takes about 2 hours in Dubai (AED 10 extra). Cash on delivery works across the UAE, or you can pay by bank transfer through a payment link sent when the delivery person arrives. The minimum order is AED 100 on all payment methods. Every item is covered by our Authenticity Guarantee, and delivery details are on the delivery terms page.

Storing spare coils in UAE heat

Keep unused coils sealed in their packaging, somewhere cool, dry and out of direct sun. Do not leave a filled pod in a parked car, where thin e-liquid can leak. Spare coils need no priming until you fit them. The empty pod they sit in is covered in our Aspire Riil X Empty Pod review.

Frequently Asked Questions

Which Aspire AF coils fit the Riil X?
Aspire lists two AF mesh coils for the Riil X: 0.6Ω rated 15-18W and 1.0Ω rated 12-15W. Vapor AE sells both in packs of five. Use only the resistances listed for your device and stay inside the wattage range shown for the coil you choose.

Do Aspire AF coils fit the Pixo?
No. The Pixo, Pixo Aura and Nexi Pro use pods with the coil built in, so there is no socket for a loose AF coil. Buy the matching replacement pod instead, and choose a resistance that suits your device and your e-liquid.

How many coils are in a pack?
Each Vapor AE pack contains five AF mesh coils in the resistance you select. At AED 49 per pack that is AED 9.80 per coil, a figure worked out from the listed price and not a manufacturer claim.

How long does an AF coil last?
Aspire does not publish a puff count for AF coils, and we have not measured one. Life varies with use, wattage and e-liquid. Replace the coil when flavour turns muted or burnt, and never fire a dry, unprimed coil.

Are these genuine Aspire coils?
Yes. Vapor AE sells genuine stock covered by its Authenticity Guarantee. Buyers must be 21 or over; age is confirmed at the website age gate.

Products on this site are for adults 21+. Read our Responsible Vaping and Health Disclaimer. Last updated: 26 September 2026.

Reviewed by Ismail Hossain, Product Specialist — Last reviewed: 28 September 2026.

Products on this site contain nicotine, an addictive substance. Sale restricted to adults 21+.

Authenticity Guarantee: https://vaporae.com/authenticity-guarantee/ | Responsible Vaping Health Disclaimer: https://vaporae.com/responsible-vaping-health-disclaimer/